3-output format
Units: knots Feet Feet
Actual: M 101.2 1006 M 1005 M
Target: 20.0 0 0
Parameter 4. Ps1 Rate Units: Unit of measurement for displaying the rate of change of the
Ps1 output. This parameter is accessible only on the 2-output format. Normally, the Ps1 Rate
unit used is ‘Feet/min’ for displaying rate of change of altitude. These units cannot be
independently chosen. Whatever the unit selected for the Ps1 output, the Ps1 Rate unit is the
per-minute rate of that selected Ps1 unit. If the Ps1 unit selected is ‘inHg’ then the Ps1 Rate
unit will be ‘inHg/min’. The currently selected Ps1 Rate unit is shown on the first line of the
display (as shown below). The two values (3500 and 3000) that appear below it are in these
units.
2-output format
Units: knots Feet/min Feet
Actual: M 101.2 3500 1005 M
Target: 20.0 3000 0
Parameter 5. Pt “Actual” value: This is the current pressure measured at the Pt output,
displayed in the current units. This parameter is accessible in both 2-output and 3-output
formats. In the sample screen shown below, the current pressure at the Pt output is 101.2
knots. This value is updated every 0.25 seconds.
2-output format
Units: knots Feet/min Feet
Actual: M 101.2 3500 1005 M
Target: 20.0 3000 0
Parameter 6. Ps1 “Actual” value: This is the current pressure measured at the Ps1
output, displayed in the current units. This parameter is accessible in both 2-output and 3-
output formats. In the sample screen shown below, the current pressure at the Ps1 output is
1005 Feet. This value is updated every 0.25 seconds.
2-output format
Units: knots Feet/min Feet
Actual: M 101.2 3500 1005 M
Target: 20.0 3000 0
To Next Page
Loading...