6.
Connect the supplied CO
2
pressure regulator to the inlet tubing. Ensure that the regulator is
fully off by turning the knob fully counterclockwise.
7.
Screw the supplied 1.5-pound CO
2
cylinder onto the regulator. DO NOT TURN THE GAS
PRESSURE ON AT THIS POINT. Place the cylinder in the side compartment ensuring the
side door properly closes.
8. Turn the power switch to ON at the rear of the dispenser.
The dispenser is now “live” and proper safety precautions should be
followed if any panels are removed from the unit.
To Next Page
Loading...