Lavit LB115 - Aqua Host Installation

22
TM170915-B
Section 2c: Aqua Host Installation
Required Materials and Tools
AquaHost Water Dispenser
AquaHost Pump Kit (PK100)
¼” NSF approved water tubing (black color recommended)
Tubing cutter
Installation Instructions
1. Install the AquaHost Pump Kit according to the instructions provided by the AquaHost
manufacturer.
2. Locate the Lavit Beverage Dispenser no more than six (6) feet away from the AquaHost
unit.
3. Connect the ¼” water tubing from the outlet of the AquaHost Pump to the water inlet
connection at rear of the Lavit dispenser.
4. Ensure that the Dispenser Power Switch is in the OFF position (bottom in). Connect the
power cord.
5.
Locate the CO
2
inlet pressure line inside the side compartment. Extend the line away from
the dispenser and trim the line using a tubing cutter so that the final length of the tube
extends to the inside of the door hinge.
It is recommended that the power cord be connected to a GFI outlet.