Need help?Do you have a question about the Lavit LB115 and is the answer not in the manual?
Details features of the dispenser's rear panel, including ports and switches.
Explains the function and status indicators of the Lavit button and touchscreen interface.
Covers disinfection, filtration, antimicrobial protection, bottle installation, transport, and CO2 cylinders.
Safety precautions and procedures for handling CO2 cylinders.
Provides a general overview of the installation process for the dispenser.
Outlines steps for inspecting the unit before installation.
Guidelines for positioning the dispenser, including clearance requirements.
Instructions for connecting the dispenser to a mains water supply.
Steps for setting up the dispenser with a 5-gallon water bottle.
Guide for installing the dispenser with an AquaHost water dispenser.
Procedure for calibrating the water streams for accurate dispensing.
Describes the main interface and icons on the dispenser's touchscreen.
How to dispense plain cold water using the Lavit Button.
Steps to select and dispense medium/large still or sparkling water.
Guide on using capsules to make tea, still, or sparkling beverages.
Instructions on selecting carbonation levels for sparkling beverages.
Steps for cleaning the internal mix chamber and related parts.
How to clean the exterior surfaces of the dispenser.
Steps to access the service menu via the touchscreen and password.
Configuration options like O3 Sanitation Time, Max Dispense Temp, Filter Timer.
How to access water stream calibration from the service menu.
Screens related to CO2 gas status and water tank levels.
Displays for water chilling progress and mix chamber status.
Screens indicating errors, leaks, and the dispenser's sleep mode.
Solutions for water dripping from the dispense area and leaks from the unit rear.
Troubleshooting no sparkling water, CO2 pressure, and soda pump problems.
Addresses dry powder or undissolved powder during dispense.
Steps to drain water and remove CO2 bottle before moving the unit.
Detailed steps for removing and reinstalling the top cover of the dispenser.
Instructions for removing the left side, right side, and rear panels.
Visual representation of the water and gas flow within the dispenser.
Wiring diagram for the control PCB and associated components.
Wiring diagram for the chiller PCB and power supply.
Illustrated breakdown of dispenser parts with reference numbers.
Illustrated breakdown of wetted parts with reference numbers and materials.
To Next Page
General