14
9. Place log onto splitter. Place the log
onto the support table vertically and
sitting flat on the support table. Be
sure the wedge and support table
will contact the log squarely on the
ends. Never attempt to split a log at
an angle.
Break log in the direction
of its growing grain. Do
not place log across the
log splitter for splitting.
It may be dangerous and
may seriously damage the
machine.
10. Adjust the Log Holders (A) according
to the diameter of the log to obtain the
most comfortable Control Levers angle.
A
Accumulated split wood
and wood chips can create a
hazardous work environment.
Never continue to work in a
cluttered work area which
may cause you to slip, trip or
fall.
11. Hold the log with clamping brackets
closely in the control lever guards.
lower levers to start the splitting.
Releasing either lever stops the
motion of the splitting wedge.
Releasing both handles to return
the splitting wedge to the upper
position.
12. Stack as you work. This will provide
a safer work area, by keeping it
uncluttered, and avoid the danger
of tripping, or damaging the power
cord.
To Next Page
Loading...