LawnMaster CLM2413A - Troubleshooting; Mower Start and Cut Issues

33
TROUBLESHOOTING
Suspected malfunctions are often due to causes that the user can x themselves.
Therefore, check the product using this section. In most cases the problem can be solved quickly.
WARNING
Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed by an authorized service center
or a similarly qualied specialist if you cannot solve the problem yourself!
PROBLEM POSSIBLE CAUSE SOLUTION
Mower fails to start.
The key is not installed. Check the key installation.
The battery is not installed
correctly.
Check connection of battery to mower.
The battery is not charged,
or power is too low.
Charge the battery.
The blade is jammed.
Stop mower and remove battery; check
for grass and debris under the deck,
clean to make blade free to move.
The battery is defective or
old.
Replace the battery (call the toll-free
helpline, at 866-384-8432).
The switch is defective.
Replace the switch (call the toll-free
helpline, at 866-384-8432).
Mower cuts unevenly.
Rough or uneven lawn. Check the mowing area.
Cutting height not set
properly.
Set the mower at a higher position.
The blade is dull. Sharpen or replace the blade.
Mower is hard to push.
High grass and low
cutting height. Rear of
mower housing and blade
dragging in heavy grass.
Raise the cutting height.