15
WRONG
ASSEMBLY
Fig. 13
Fig. 12
INSTALLING THE SHOULDER STRAP (SOLD SEPARATELY) (See Figs. 14-18)
A removable shoulder strap and shoulder strap clasp (not included) are sold separately for your convenience.
Use of a shoulder strap is recommended for trimmer and brush cutter use.
■ Remove the pre-installed screw from the shoulder strap clasp.
■ Place the shoulder strap clasp against the drive shaft with the tapped hole on the left (viewed from the
engine).
■ Squeeze the two ends of the clasp together and hold in that position. Secure the clasp with the screw
(Fig. 14).
Fig. 14
■ Place the shoulder strap over your left shoulder and across your chest. Adjust the length of the strap. Make
sure the release latch of the strap is below your right waist level (Fig. 15).
■ Attach the shoulder strap hook to the shoulder strap clasp (Fig. 16).
To Next Page
Loading...
Need help?
General
