21
OPERATION
FILLING THE FUEL TANK (See Fig. 22)
NOTICE: Before each use, ALWAYS shake the fuel container thoroughly to ensure that the fuel is
mixed completely.
■ Place the tool on a at, level surface, outdoors. Ensure the fuel tank and the shaft are in the same
level so enough fuel can be lled into the fuel tank.
■ Clean the area around the fuel tank and cap to prevent any contamination.
■ Loosen the fuel tank cap by turning it counter-clockwise and remove (Fig. 22).
■ Carefully pour the fuel into the fuel tank, avoiding any spillage. Clean and check the gasket before
replacing the cap onto the fuel tank.
■ DO NOT leave the fuel tank unsealed while it contains fuel. Replace the cap immediately after lling
and inspecting the tank. Check that the cap is sealed tightly and wipe clean any spillage that may
have occurred.
NOTICE: It is normal for smoke to be emitted from a new engine after rst use.
WARNING
The operation of this tool requires gasoline, an extremely ammable liquid. Always turn off the engine
and allow it to cool completely before fueling. Never remove the fuel tank cap or add the fuel to the tool
while it is running or the engine is still hot. Make sure to fuel the tool outdoors on a at, level surface.
After fueling, immediately replace the fuel tank cap and tighten it securely. DO NOT ll the fuel tank
on the work site; fueling must occur at least 10 ft. (3m) from where the operator intends to start the
engine. Keep the tool away from smoke, open ames and sparks! Failure to follow these instructions
could result in an explosion, re and cause serious personal injury.
Fig. 22
Gasket
To Next Page
Loading...
Need help?
General
