23
OPERATION
■ Lift the start button cover, press the start button and keep pressed until the engine starts. Manually
turn the choke lever to the RUN position. For best results, let the engine warm up at idle for at least
1 minute, or lightly engage the throttle to speed up the process. Engaging the throttle fully before
the trimmer is warm can cause the engine to stall (Fig. 26 - 28).
■ To begin trimming, engage the throttle safety and the throttle lever. Do not engage the throttle while
pressing the start button (Fig. 29 - 30).
■ If the choke lever is left on choke, the grass trimmer will stop running in 15-30 seconds.
NOTE: If the engine does not start, manually turn the choke lever to the RUN position, and hold the
start button down until the engine starts.
■ If the trimmer continues to fail to start, refer to the Troubleshooting section on pages 37 - 38.
Fig. 26 Fig. 27
Fig. 28Fig. 29
Fig. 30
For warm start:
■ Make sure that the battery pack is securely in place.
■ Place the trimmer on a levelled surface, outdoors.
■ Press the primer bulb 5 times or until the bulb lls with fuel.
■ Make sure the choke lever in the RUN position.
■ Lift the start button cover, press the start button and keep pressed until the engine starts. Then
engage the throttle safety and the throttle lever to start the trimmer.
To stop the trimmer: Press the STOP switch to the stop position “O” until the trimmer stops (Fig. 31).
Fig. 31
To Next Page
Loading...
Need help?
General
