31
TROUBLESHOOTING
Grass is being cut
unevenly.
Working area is too big.
Recharge the battery to mow the
area twice or purchase an additional
area.
Blades are dull.
Replace all the blades and screws.
Refer to Replacing the Mower Blade
section on page 26-27. Visit www.
cleva-europe.com for info on where to
buy blades.
Height of cut is too low, or the
grass is too high.
Increase the height of cut.
There is grass wrapped around
the blade disc.
Check underneath the mower and
enough.
Height of cut is too low, or the
grass is too high.
Increase the height of cut.
The grass is wet or damp. Wait until the grass is dry.
The grass is dense.
Increase the height of cut and cut
more frequently.
The battery is not fully charged. Charge the battery.
The lawn area is too large.
Recharge the battery and mow again
or purchase an additional battery for
extended mowing of larger areas.
The cutting blade is
not rotating while the
mower is switched
on.
The cutting blade is obstructed.
Remove the isolator key and the
battery pack. Clear obstruction
The blade screw is loose. Tighten the blade screws.
Error indicator is
yellow continuous.
The lift sensor is activated for 10
seconds.
Remove and re-insert the isolator key.
Check the working area for obstacles
taller than 10 cm and remove them.
Restart the mower.
The obstruction sensor has
tripped 10 times within one
minute.
Remove and re-insert the isolator
key. Remove any obstacles. Check
whether the grass is too tall. If
necessary, mow the grass to below 60
mm with a conventional lawn mower.
Restart the mower.
To Next Page
Loading...
