LCF Technics VLCD5 - VLCD5 Features

To Next Page

To Previous Page

LCF Technics Product User Guide

VLCD5 Features

1. Speed display - Reads our the current speed in Kph or Mph as configured.

2. Battery Level indicator - 4 block indication of battery charge level - each block represents

approx. 25%. The level indicator flashes when the battery is low.

3. Trip distance - reset on power off.

4. Odometer - Total miles from new.

5. Trip Time - Time in use for the current trip.

6. Average speed（AVG）

7. Power assist level - Eco, Tour, Speed, Turbo or off.

8. Backlight - off (default) or on. Also turns on optional external lights if fitted.

9. Wheel-diameter setting - in inches - range 14 - 32. 26 is default. The diameter setting

must be correct for speed and range function accuracy.

10. Magnetic pickup sensor setting – Number of spoke magnets – default is 1.

11. Speed units - Select imperial (Mph) or Metric (Kph).

12. Walk assist / 6kph setting - ON or OFF - default is OFF.

13. Maximum assist speed limit - Default is 25Km/h

14. Assist ratio setting (reserved) - Default is 16.

15. Zone setting (reserved) - Default is Europe.

16. Software version - Displays current firmware version.

17. Error code - System does a power on self test - detected errors display a code.

18. Torque signal value (reserved) - Current torque value readout.

19. Initial torque value (reserved) - Initial torque signal value displays.

LCF Technics Limited | The Old Library, Remount Farm, Lusk, Co Dublin, Ireland, K45 XP26 | https://lcftechnics.eu/

Page 7