“ ”button≥5S, the parameter on the interface will be flash,
here is set up state. Loose the button, press“ ” button
again could operate plus data, press“ ” button could
operate minus data. After finish the needed technical data,
long press“ ”button again ≥5S, the parameter save and
come out set up state. If 20s no any operation, automatically
back to main interface.
b) Low Voltage Reconnection Voltage (LVR)
When the voltage of battery is low,
the control will stop offer power to
the load. If the controller needs
reconnected the output, the
voltage of battery must be higher
than LVD voltage or press “ ”button force to release. The
procedure is same with (a).
c) Low Voltage Disconnection Voltage
When the voltage of battery is low, the load output will be cut
off. When the controller detected the battery voltage was
less than LVD point, the cut off function will be immediately
To Next Page
Loading...