working. At the same time,
the status of controller is in
lock. Users have to charge
the battery, when the battery
voltage is higher than LVD
voltage or press“ ”button force to release. The load
output will be back. The procedure is same with (a).
Above a、b、c three parameter default data
was fully considered by designer according
to the actual use. Generally users don’t
need to adjust. Please must be refer to battery
supplier’s suggestion, or the battery will be damaged or
irreparable destroy.
d) Load Working Mode Selection
working 24hours. When the
24hours, the load will keep
working 24hours in no fault status. When the load working
To Next Page
Loading...