- 9 -
ENGLISH
Warnings
- This manual is intended only for qualified technical staff and not for
end users. It is responsibility of installer to inform end user on the
use of the operator and on dangers that could derive from it,
as well as on the need of a periodical maintenance.
- The set up is to be carried on only by qualified staff with necessary
technical and professional requirements.
- The product is to be installed complying with rules in force for
automatic gate.
- The device has been realised only to automate sliding gates.
Any other is to be considered improper and thereforeuse
forbidden.
- Always use original components. Company L electronics won’teb
take any responsibilities for damages due to the use of non-original
components.
- turdyBefore proceeding with set up, make sure the gate frame is s
and suitable for the of the .use operator
- Before proceeding with set up, make sure that the gate can freely
slide and that it cannot derail off from its rail.
- Before operating on the device, check the power supply voltage is
disconnected.
- Fix with a special care the safety devices to be installed and the
place where they are to be positioned. Furthermore insert an
emergency stop device, allowing the cut of the electric power
supply.
- The equipment is not to be handled by children or incompetents.
- In case of lack of electric mains, use the unlocking tolever
manually open or close the gate.
- Maintenance of the is to be carried out only by qualifiedoperator
staff authorized by the Manufacturer.
- Check every six-months that gate wheels are in good conditions
and well lubricated.
To Next Page
Loading...
Need help?
General
