LECAI Science And Technology LC Easyjet-18S User Manual

LC Easyjet-16W/18S User Manual V13GZ.1
59
print head.
 If the printer is not operated less than 4 days, please fill the maintenance capper with
cleaning solution and move the print head to stay on the maintenance capper to make sure
the head keep being moist, refer to the 3.1.7.2.5.
 If the printer is not operated over 4 days, please dismantle the print head and clean it with
cleaning solution. After clean all the ink left in the head, then cover the head with a piece of
special wipe cloth (with cleaning solution) and then cover it with plastic film.
 The spare parts and consumables from LECAI are recommended, LECAI will not be liable
for the damage of printer caused by using the spare parts and consumables from other
suppliers.
7 Trouble Shooting
Problems
Reason
Resolution
Turn on but the
LCD can’t
show
1.Power cable.
2 .LCD cable.
3. Mainboard fuse.
4.Power board.
5.Mainboard
6.LCD
1. Change the power cable.
2. Re-plug in the LCD cable.
3. Test by multimeter whether there is voltage.
4. Change the mainboard fuse.
5. Check whether the transformer has voltage.
6. Check the mainboard power cable.
7. Change the mainboard.
8. Change the LCD.
Turn on but
Carriage can’t
move
1. Motor cable.
2. Operation panel cable
3. Mainboard fuse
4. Mainboard
5. .Motor
1. Re-plug in the motor cable
2. Re-plug in the Operation panel cable.
3. Change the mainboard fuse.
4. Change the mainboard.
5. Change the Motor.
Output form
Maintop but
printer no
response
1.IP address
2.Network cable
3.Maintop software
4.Computer
5.Mainboard
1. Set up the PC IP address 196.12.0.188
2. Change the network cable.
3. Setup Maintop printer.
4. Click Maintop Manager “Start” icon to start print.
5. Re-install the Maintop software.
6. Use another computer .
7. Change the mainboard.
carriage rushes
out from the
station and
rushes back
1.Raster sensor
2.Raster
1. Check the raster sensor position.
2. Change the raster sensor.
3. Clean the raster.
4. Change the raster.
Print misting
1. Static.
2. Media.
3. Voltage
4. Print head height
5. Working Environment
6. Speed
1. Connect the earth lead and test by multimeter.
2. Use other media to try.
3. Use UPS.
4. Adjust the print head about 1.5mm.
5. Temperature：18°- 35°Humidity：35RH - 65RH.

LECAI Science And Technology LC Easyjet-18S Specifications

General

Brand	LECAI Science And Technology
Model	LC Easyjet-18S
Category	Printer
Language	English