Leckey BeMe User Manual p43
SECTION 16.1:
ATTACHING AND
DETACHING SEATING
UNIT TO CHASSIS
Adjust the height of the chassis to its
maximum to reduce risk of back strain while
attaching the seat base. Refer to Section 9 on
how to adjust the height of the chassis you
have purchased.
Before attaching the seat base, ensure the
locking latch at the front is released
. If the
locking latch is locked
, then the following
steps should be completed.
Locate the right and left grey locking latch
release buttons at the front of the seat
.
Simultaneously rotate the buttons towards the
centre of the seat
, and then press inwards,
E
. An audible click will be heard when the
latches release.
Image of locking latch locked
E
To Next Page
Loading...
