p44 Leckey BeMe User Manual
Once the locking latches are released the seat
base can be placed on the chassis. Lift the
seat base with both hands at either side of the
seat base. On the rear of the seat base there
are two hooks
F
, which are to be aligned
with the rear tube of the chassis interface
G
.
Rotate the front of the seat down
H
, pressing
down firmly until an audible click of the
locking latches locking is heard.
Check that it is secure by pulling up on the
front and rear of the seat core.
To detach the seat, locate and release the
locking latches as shown in
, and
E
. Then reverse the attachment steps by
following
H
,
G
and
F
.
Always ensure the seat base is
attached securely.
Use caution when attaching
seat as there could be possible
finger nip.
F
G
H
To Next Page
Loading...
