Leckey BeMe - Page 87

Leckey BeMe User Manual p87
SECTION 17.5:
ATTACHING AND
DETACHING BASIC
BACKREST FOAM
To attach the basic backrest foam, locate the
holes at the top and bottom of the foam
. Place the washer on the screw , and
pass the screw through the holes in the foam
and the corresponding holes in the
platework
.
Using a spanner, secure all four screws in
place with a nut
, so that the end of the
screw sits flush with the end of the nut
E
.
E
To detach the basic backrest foam, reverse
the process.