p8 Squiggles Stander - User Manual
This is especially important when
the support frame is in a reclined
position.
8. When the product is in use please
ensure that the angle adjustment
lever on the Pivot chassis or the
locking bolts on the Easel chassis
and Mobile chassis are locked off
and cannot be adjusted accidentally,
especially if there are children in the
area.
9. When the Leckey Squiggles Stander
is used on the Pivot chassis we do not
recommend that users are moved
over uneven surfaces when in the
equipment. When using easel chassis
always remove the child from the
stander before moving. All due care
and attention should be taken if
transporting the user in and out of
the stander.
10. Never leave the product on a sloping
surface, greater than 5 degrees.
Always remember to lock all the
castors.
11. Although the Pivot stander is fitted
with castors this is not a mobility
device. Always place the user in an
upright position before moving the
stander. Hold the back of the plastic
chest support when moving the
stander.
12. The product contains components
which could present a choking
hazard to small children. Always
check that locking knobs and bolts
within the child’s reach are tightened
and secure at all times.
13. Leckey products comply with fire
safety regulations in accordance
with EN12182. However the product
contains plastic components and
therefore should be kept away from
all direct sources of heat including
naked flames, cigarettes, electric and
gas heaters.
14. Do not place hot objects greater than
40ºC on the tray.
15. Clean the product regularly. Do not
use abrasive cleaners. Carry out
maintenance checks on a regular
basis to ensure your product is in
good working condition.
16. The product is designed for indoor
use (unless used with the Mobile
chassis) and when not in use
should be stored in a dry place
that is not subjected to extremes
of temperature. The safe operating
temperature range of the product is
+5 to +40 deg Celsius.
To Next Page
Loading...
