p18 Squiggles Stander - User Manual
SECTION 10:
FITTING THE CUSHIONS
10.1 CHEST AND HIP
CUSHIONS
Place the cushion centrally on the chest/
hip support plate. Feed the upper tab,
which has the snap fastener attached,
over the top of the moulding and snap
in place. Bring the lower tab under the
support and attach the upper tab using
the Velcro panels.
10.2 LATERAL
CUSHIONS
To attach the lateral support padded
cushions, simply slide the cushions on
with the padded side towards the inside
of the stander. Sleeve the plastic buckle
through the slot in the cover. Then
bring the two Velcro fastener straps
around the bottom of the moulding
and attach them to the Velcro panel as
shown. Close over the flap .
10.3 CHEST SUPPORT
HARNESS
The Chest support can be attached
by clipping the male buckle into the
female buckle at either side of the lateral
supports.
To Next Page
Loading...
