Lectrosonics DM1612 - Page 47

Lectrosonics DM1612

48 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

47

Reference Manual for Operation

Rio Rancho, NM – USA

Table of Contents

Default Chapter3
- Important Safety Instructions3
- Table of Contents5
General Overview9
- Signal Flow9
- Input Processing11
- Digital Matrix12
- Output Processing13
Hardware Front Panels15
Hardware Rear Panels16
LCD Interface17
- Operation with Front Panel Controls17
  - Note17
  - Boot Sequence Screens17
General Overview - Menus and Screens18
- Top Menu18
- Setup Menu18
- Setup Screens18
- Input Setup19
- Matrix Crosspoint Setup Screens20
- Output Setup Screens21
- Preset Setup Screens22
- Stacking Multiple Units23
- System Information23
- General Settings23
- Locking out the Front Panel Controls24
  - Topmenu - Lockset24
  - Lock Setup - Entering the Passcode24
- Restoring the Default Passcode24
- Changing the Passcode25
- Command View Screen26
- Serial Port Speed Adjustment26
- Leaving the Top Menu26
Installing Lecnet2™ Software and USB Driver27
- Installing Lecnet2 Software27
- Installing the Lecnet2 USB Driver27
- USB Driver Installation Windows XP)27
- First Time Installation27
- Installation Additional Venue Receivers (or Lecnet2 Devices)28
- USB Driver Installation (Windows 2000)29
  - First Time Installation29
Firmware Updates30
- Using the Update Wizard30
Serial Interface & Control Commands33
- DM1624 General Commands33
- DM1624 Audio Input Commands33
Serial Interface & Control Commands (Cont'D)34
- Ingn (Input Gain)34
- Iniv (Input Phase Invert)34
- Inlb (Input Channel Label)34
- Inlv (Input Level)34
- Inmt (Input Mute)34
Serial Interface & Control Commands (Cont'D)35
- Inmttog (Input Mute Toggle)35
- Inph (Input Phantom Power)35
- DM1624 Matrix Crosspoint Commands35
  - Xpgn (Crosspoint Gain)35
  - Xpmode (Crosspoint MIX Mode)35
Serial Interface & Control Commands (Cont'D)36
- Xpmt (Crosspoint Mute)36
- Xpmttog (Crosspoint Mute Toggle)36
- DM1624 Audio Output Commands36
  - Outdel (Output Delay)36
  - Outgn (Output Gain)36
Serial Interface & Control Commands (Cont'D)37
- Outlb (Output Channel Label)37
- Outlv (Output Level)37
- Outmic (Output MIC Level)37
- Outmt (Output Mute)37
- Outmttog (Output Mute Toggle)37
- Outsrc (Output Signal Source)37
Serial Interface & Control Commands (Cont'D)38
- DM1624 Input Compressor Commands38
Serial Interface & Control Commands (Cont'D)39
- DM1624 Output Compressor Commands39
Serial Interface & Control Commands (Cont'D)40
- DM1624 Output Limiter Commands40
- DM1624 Programmable I/O Commands40
  - Prgin (Programmable Input State)40
  - Prgout (Programmable Output State)40
Serial Interface & Control Commands (Cont'D)41
- Prgoutht (Programmable Output Channel Activity Hold Time)41
- Prgoutqt (Programmable Output Channel Activity Qualification Time)41
- DM1624 Rear Panel Control Commands41
  - Rpingn (Rear Panel Audio Input Gain)41
  - Rpingnmin (Rear Panel Audio Input Gain Minimum)41
Serial Interface & Control Commands (Cont'D)42
- Rpingnpre (Rear Panel Audio Input Gain Preset)42
- Rpingnst (Rear Panel Input Gain Step Change)42
- Rpoutgn (Rear Panel Audio Output Gain)42
- Rpoutgnmin (Rear Panel Audio Output Gain Minimum)42
- Rpoutgnpre (Rear Panel Audio Output Gain Preset)42
Serial Interface & Control Commands (Cont'D)43
- Rprest (Restore Rear Panel Settings)43
- Rpsave (Save Rear Panel Settings)43
- DM1624 ADFE Commands43
Serial Interface & Control Commands (Cont'D)44
- ADFE Filter Numbers Mapped to Center Frequencies44
Macros and Macro Control45
- About Macros45
Rear Panel Control - Hardware46