LECTROSONICS, INC.6
Hold DOWN arrow at turn on.
Hold the DOWN arrow button in while pressing both AUDIO and FREQ but‑
tons to access the setup screens below. It’s easier if you lay the unit on a flat
surface and use two hands to press all three buttons at the same time. After
the first screen loads, press the AUDIO button repeatedly to switch between
the settings. Press the UP and DOWN arrow buttons for the desired selection.
After the settings are made, press both AUDIO and FREQ buttons together to
exit and turn the power off.
rc (remote control with mobile app)
Allows the transmitter to respond to remote control “dweedle” tones from a
mobile device, or from tones generated by the Lectrosonics RM and RM2
devices.
on
Enables the remote function.
oFF
Disables the remote function.
PbAc (auto power restore)
Sets the transmitter to automatically turn back on and return to the previous
state after a battery change or power interruption when it is in the operating
mode.
1 Restores power automatically
0 Does not restore power automatically
bL (backlight settings)
Adjusts how long the LCD stays lit after pressing buttons.
5
5 minutes
30
30 seconds
on
Stays on
To Next Page
Loading...
