To Next PageTo Next Page
Need help?Do you have a question about the Lectrosonics SMDB/E01 Series and is the answer not in the manual?
Highlights key features like lightweight, water-resistant housing and compandor-free audio quality.
Provides an automatically regulated voltage for electret microphone compatibility.
Combines 24-bit digital audio with analog FM for enhanced performance.
Adjustable setting to control subsonic and very low frequency audio content.
DSP-controlled analog audio limiter with over 30 dB range for overload protection.
Monitored by microprocessor and works with DSP for audio encoding.
Designed for Digital Hybrid and IFB receivers for optimal performance.
Lectrosonics block numbering system organizes available frequency ranges.
Numeric LCD for settings and bicolor LEDs for audio/battery status.
Explains the function of AUDIO, FREQ, and Up/Down arrow buttons.
Screens for adjusting audio gain, LF roll-off, and operating frequency.
Features for locking controls and configuring remote operation.
Steps for powering on the unit and the boot sequence display.
Instructions on how to properly turn off the transmitter.
Sets the transmitter for Digital Hybrid or IFB receiver compatibility.
How to select the operating frequency in MHz or hexadecimal.
Adjusts the low frequency roll-off setting from 35 to 150 Hz.
Details pin assignments for microphone and line level inputs.
Step-by-step guide for attaching the TA5F connector to a microphone cable.
Instructions for preparing microphone cables for connector termination.
Guide for crimping cable shield and insulation for ruggedness.
Defines standard and alternative hookups for line level signals.
Wiring diagrams for various microphones compatible with servo bias inputs.
Simplified wiring diagrams for specific microphone types using servo bias.
Instructions for turning the RM/E remote control unit on and off.
Details the available adjustment screens and functions on the RM/E.
Key points regarding transmitter sensitivity and remote control interaction.
A quick summary of RM/E functions and button combinations for operation.
Solutions for transmitter power LED and audio level LED problems.
Troubleshooting for RF indicator off, no sound, distorted sound, and feedback.
Addresses hiss, noise, dropouts, and panel display messages like 'Loc', 'Hold', 'PLL'.
Troubleshooting for transmitter not responding to the RM/E remote control.
Guide to antenna whip length based on frequency block and color coding.
Lists optional accessories available for purchase.
How to set the audio input level using Modulation LEDs for optimal signal.
Protects the transmitter from accidental changes to its settings.
Procedure for securely attaching microphone connectors to the transmitter.
Lists the available operating frequency blocks and ranges.
Details battery types, life estimates, and requirements.
Covers audio response, SNR, distortion, and limiter characteristics.
Steps to follow for timely service and repair of equipment.
General| Brand | Lectrosonics |
|---|---|
| Model | SMDB/E01 Series |
| Category | Transmitter |
| Language | English |
