Lecureux TE-QC - Table of the Telegram Numbers

Operating manual TE-QC & TE-Light
LECUREUX SA 33
13.1 Table of the telegram numbers
M = Screwdriver
PC = Computer
Telegram-
number
Designation
Direction
50
Receipt
M  PC
100
PC requests all initialization data of the screwdriver
PC  M
102
PC requests the firmware version of the screwdriver
PC  M
103
PC requests the number of screw connections made
PC  M
104
PC deletes the screw counter
PC  M
106
PC starts a new screwing cycle
PC  M
107
PC aborts the running screwing cycle
PC  M
108
PC sends all initialization data to the screwdriver
PC  M
109
PC requests the name of the currently connected motor
PC  M
110
PC requests storing of the initialization data in the Flash
PC  M
111
PC sends direction of rotation
PC  M
112
PC requests data of program No 1
PC  M
113
PC requests data of program No 2
PC  M
114
PC requests data of program No 3
PC  M
115
PC requests data of program No 4
PC  M
116
PC requests data of program No 5
PC  M
117
PC requests data of program No 6
PC  M
118
PC requests data of program No 7
PC  M
119
PC requests data of program No 8
PC  M
120
PC sends data of program No 1
PC  M
121
PC sends data of program No 2
PC  M
122
PC sends data of program No 3
PC  M
123
PC sends data of program No 4
PC  M
124
PC sends data of program No 5
PC  M
125
PC sends data of program No 6
PC  M
126
PC sends data of program No 7
PC  M
127
PC sends data of program No 8
PC  M
128
PC requests protection data
PC  M
129
PC sends protection data
PC  M
130
PC requests the value of the torque calibration. The screwdriver
responds with the actually configured value.
PC  M
131
PC sends the desired value to use for torque calibration.
PC  M
132
PC requests the status of the screwdriver. The screwdriver responds
with the value of the actual status.
PC  M
133
PC erases an eventually displayed error message of the screwdriver.
PC  M
150
The screwdriver sends measured torque to PC
M  PC
151
The screwdriver sends ramp data
M  PC
152
The screwdriver sends torque reached
M  PC
153
The screwdriver sends the screwing cycle start
M  PC
154
The screwdriver sends the screwing cycle end
M  PC
155
The screwdriver sends the number of the current program
M  PC