LIPS Protocol Headers For further information, please contact Leema Technical Support.
Value = 20 ID header. This header is private and must not be issued by any controlling software.
Value = 30 This is a general command header. The command values are as follows:
10 = Infra Red control OFF. These commands control the local IR receiver
20 = Infra Red control ON
100 = Power ON
101 = Power OFF
102 = Select Input PHONO
103 = Select Input CD
104 = Select Input TUNER
105 = Select Input AUX
106 = Select Input MULTI 1
107 = Select Input MULTI 2
108 = Select Input AV DIRECT
109 = Select Input TAPE
110 = LED ring ON
111 = LED ring OFF
Value = 40 Volume header. Valid command values are 0(mute) to 248(maximum volume)
Value = 50 Serial Pass Through. When a Tucana, Hydra or Corvus receives this header, the header and value are passed
on up the bus. This enables future expansion options.
Value = 60 This is issued by Corvus. The command value contains the sub filter frequency.
Value = 70 This is issued by Corvus. The command value contains the sub filter slope.
Value = 80 This is issued by Corvus. The command value contains the extract status.
Value = 90 Antila/Stream direct track access. Valid command values are 1 - 99 for tracks 1 - 99.
Value = 100 Spare header for future use.
LIPS
STREAM
15
To Next Page
Loading...