LEGA
LEGA LEGA
LEGA
srl
srlsrl
srl
C
CC
Costruzioni
ostruzioni ostruzioni
ostruzioni A
AA
Apistiche
pistichepistiche
pistiche
–
––
–
via Maestri del Lavoro 23
via Maestri del Lavoro 23 via Maestri del Lavoro 23
via Maestri del Lavoro 23 –
––
–
48018 Faenza
48018 Faenza48018 Faenza
48018 Faenza
www.legaitaly.com
www.legaitaly.com www.legaitaly.com
www.legaitaly.com -
--
-
Tel 054626834
Tel 054626834 Tel 054626834
Tel 054626834 –
––
–
Fa
FaFa
Fax 054628279
x 054628279 x 054628279
x 054628279 –
––
–
P.iva 00043230390
P.iva 00043230390P.iva 00043230390
P.iva 00043230390
21 / 68
If you expect not to use the machine for a prolonged period of time, check the state of repair of its mechanical
parts and carry out any required checking, replacement or maintenance to ensure that the machine is ready for
use upon the next power-on.
Before periods of prolonged inactivity, coat the chromium plated parts of the machine with a thin film of paraffin
oil and then cover the machine with a tarpaulin.
4.1 LOGO PROGRAMMING INSTRUCTIONS
4.1 LOGO PROGRAMMING INSTRUCTIONS4.1 LOGO PROGRAMMING INSTRUCTIONS
4.1 LOGO PROGRAMMING INSTRUCTIONS
5)
Plug the rotating loader into line power and switch on the main switch (25) located in the control panel
(ref. fig. 3).
6)
After restoring the emergency control, parameter setting-up can be carried out.
7)
To select the correct (SET PARAM) field, press the key F4 and then ESC to access the list shown in the
screen display picture here below.
8)
Highlight Set Param with the arrow UP (1) or arrow DOWN (4) key then press OK (5).
5) Once on the program to modify, press OK (5).
- T refers to the time setting, while Ta is the operation timer.
Only the T value can be modified as is clearly visible -
The LOGO! pre-set data are:
To Next Page
Loading...