Lega 6962 - Faults, Causes, and Remedies

LEGA
LEGA LEGA
LEGA srl
srlsrl
srl C
CC
Costruzioni
ostruzioni ostruzioni
ostruzioni A
AA
Apistiche
pistichepistiche
pistiche –
––
– via Maestri del Lavoro 23
via Maestri del Lavoro 23 via Maestri del Lavoro 23
via Maestri del Lavoro 23 –
––
– 48018 Faenza
48018 Faenza48018 Faenza
48018 Faenza
www.legaitaly.com
www.legaitaly.com www.legaitaly.com
www.legaitaly.com -
--
- Tel 054626834
Tel 054626834 Tel 054626834
Tel 054626834 –
––
– Fa
FaFa
Fax 054628279
x 054628279 x 054628279
x 054628279 –
––
– P.iva 00043230390
P.iva 00043230390P.iva 00043230390
P.iva 00043230390
23 / 68
5.1 FAULTS, CAUSES AND REMEDIES
5.1 FAULTS, CAUSES AND REMEDIES5.1 FAULTS, CAUSES AND REMEDIES
5.1 FAULTS, CAUSES AND REMEDIES
Our After-sales staff can be contacted by telephone or fax during work hours for any information or technical
advice in regard to the machine; however, before contacting our after-sales service, please check the
information provided here below.
Check that the cable connections are tight.
-
--
- The plate will not stop wh
The plate will not stop whThe plate will not stop wh
The plate will not stop when a jar is fed past the microswitch:
en a jar is fed past the microswitch:en a jar is fed past the microswitch:
en a jar is fed past the microswitch:
Microswitch too far from jar. Adjust position.
Faulty control unit connection. Check all controls.
Cable break. Check for continuity.
-
--
- The packing machine will not work even in the presence of a jar in front of the
The packing machine will not work even in the presence of a jar in front of theThe packing machine will not work even in the presence of a jar in front of the
The packing machine will not work even in the presence of a jar in front of the microswitch:
microswitch:microswitch:
microswitch:
No air feeding to the pneumatic system. Check the pneumatic system.
No signal to the solenoid valve. Check for cable continuity.
Packing machine fault. Check the packing machine manual.
The electronic components used are highly reliable and their operation is thoroughly tested in practical
situations on-board the machine. However, we are ready to ensure minimised down-time requirements in case
of problems affecting the components.