4. PREPARATION –CONNECTION
(continued)
Supply:
. No power supply.
Assembling:
. Between two modular protection devices (see the association table
for the type of products to associate)
. Clipped on the associated device by mean of plastic clamps present
on each side of MSI.
. Assembling on the right side
. Assembling on the left side
Tools required:
. Fixing the MSI and protection devices: no tools.
. Fixing on the DIN rail: no tools.
. To remove the security seals: flat screwdriver 5,5 mm (6 mm
maximum).
Lockout:
. The MSI is equipped with security seals that ensure the association
between MSI and the associated device.
. By padlock on the associated device (cat. nos 4 063 13 or 227 97),
and padlock support (cat. no 4 063 03) on the device (MCB or IS)
powered-on.
4. PREPARATION –CONNECTION
(continued)
Operation:
. To perform the source inversion:
1. Lower the handle of the protection device powered-on.
2. Slide the frontal slider on the device with the handle lowered.
3. Lift the handle of the other circuit breaker to restore the supply.
Association table
. To the left and right of the Manual Supply Invertor must be installed
the same type of devices (IS-IS or MCB-MCB).
To Next Page
Loading...
Need help?
General
