11
LED Indicator
1-3kVA
Symbol Description
Normal Mode LED
1. Solid indicates normal utility voltage. Blinking indicates insufficient utility
voltage for the full load. Off indicates abnormal utility voltage.
2. In Battery and Load Function mode indicates battery capacity is 50%.
Bypass Mode LED
1. Indicates load supplied by Bypass.
2. In Battery and Load Function mode indicates battery capacity is 75%.
Outlet1 LED
1. Indicates UPS Outlets 1 are enabled and ready to supply loads.
(This function is optional.)
2. In Battery and Load Function mode indicates load capacity is 75%.
3. In Error Code Function mode indicates Error Code 4.
Outlet2 LED
1. Indicates UPS Outlets 2 are enabled and ready to supply loads.
(This function is optional.)
2. In Battery and Load Function mode indicates load capacity is 25%.
3. In Error Code Function mode indicates Error Code 1.
2.3 Panel Explanation
2.3.1 Front Panel for 5-10kVA
1 LCD Information
2 Green LED indicates that the UPS is able to run under redundancy mode
3 Solid green LED indicates that the utility input voltage is within the window
Flashing green LED indicates that the utility input voltage is outside the acceptable window
4 Green LED indicates that Bypass Input is normal
5 UPS ON/Alarm Silence
6 Go to previous page or change the setting of the UPS
7 Confirm a changed setting
8 Go to the next page
9 UPS OFF Switch
10 Special functions log in/out
11 UPS is working under ECO (Economical) mode
12 UPS Fault or Abnormal
Parallal ID Mode
Bypass Stop
Utility Invertar
Voltage Adjust
Frequency Window
Buzzer Code
Battery Autonomy
KVA
WHz
Mine
%
0
C
12
N+1
ECO
unction
5910 8
6
7
134211 12
INPUT LOAD
Foult
Low
Testing
UPS
Overload
Service
Bypass
Utility
?
Alarm
Wiring Fault
!
!
To Next Page
Loading...
