7
7. Base and fixing
You can use the fixing screws supplied with the Lehle
Mono Volume to fix it to a base plate (or to a pedal
board, for example).
The base of the Lehle Mono Volume can be
easily attached on any base plate with Velcro or
the supplied screws. First, we recommend you to
pull out the rubber pads on the bottom. If a rubber
buffer gets lost in this process or breaks, you will
get a replacement at any time.
Fixing the Lehle Mono Volume with screws:
Place the volume pedal without the rubber buffers
in the position where you want to attach it to the
board. Use a fine-point pen or a sharp pencil to
sketch the subsequent screw holes through the
mounting holes onto the base plate. Now drill
at the site of the later screw holes a hole with a
diameter of approximately 2.5 mm (1/10 inch).
Then turn in the two screws for the U-shaped
mounting holes together with the washers just
halfway.
Slide the volume pedal with the U-shaped mount-
ing holes under the screw heads of the screws
already turned in. Make sure that the washers are
placed between the bottom plate of the Lehle
Mono Volume and the screw head, to protect the
paint.
Now you can turn in the remaining two screws
and spacers through the two round mounting
holes next to the jack plugs. Tighten those screws
only slightly, then fix the screws you first turned in.
This type of mounting is extremely stable and can
also be easily removed.
Tip: In case you prefer a Velcro solution for your
pedal board we recommend to write down the
serial number of the pedal for eventual support
matters before covering it.
To Next Page
Loading...
Need help?
General
