Group 7 Data/Programming Page 133
Release R2.0 LEIBINGER JET3
Press on the tab <Factory Settings> (2) to select the tab.
Press the button <Reset> (3).
A Safety query (4) if you would like to continue with the process is faded in.
Press the button <Cancel> (5) to abort the process or press the button <OK>
(6) to reset the device.
The message <Restart> (7) is faded in.
Press the button <OK> (8). The device is shut down automatically and will be
rebooted afterwards. After this process the JET3 is reset to the standard settings.
With the tab <IP-Address> you can carry out the addressing of the device.
If the LEIBINGER JET3 will be integrated in a network which is based on an internet
protocol, an IP-address has to be assigned to the device.
As standard the IP-address is preallocated by the company Leibinger and can be
adjusted to the customer demands.
Press on the bar <IP-Address> (2) to select the tab.
Click in the setting field which should be changed on the requested address block
(6). A Numeric keypad (7) opens for input in which you can enter the required
value.
You will find further information regarding working with Numeric
keypads in the chapter Numeric keypad!
Now carry out the settings for every further address block accordingly.
To Next Page
Loading...
