Group 7 Data/Programming Page 177
Release R2.0 LEIBINGER JET3
7.5.3.2 Stop after x products (Pre-defined print stop)
With the option <Stop after x Products> the amount of prints will be defined after
the LEIBINGER JET3 should release an automatic print stop.
If a print stop has been pre-defined the value is displayed in the status field
<Production Counter> of the main menu.
Before the re-start of the production, the production counter has to be
necessarily reset to get a correct result.
Press the option <Stop after x Products> (2).
The window <Stop at x Products> (3) is faded in.
Change the value of the print stop counter with the Arrow keys (4). The value of
the counter will be increased or reduced in single steps by pressing the accordant
buttons.
or
Click in the Counter display field (5). The Numeric keypad (6) opens for input.
You will find further information regarding the working with Numeric
keypads in the chapter Numeric keypad!
Confirm the changed value by pressing on the button <Set> (7) or cancel the
process with the button <Cancel> (8).
The set print stop value is now displayed in the status field <Product Counter>
(9) of the main menu. For better visualization that a pre-defined print stop has
been defined, the field is displayed with a red frame.
If the x-value set is equal or lower than the value set for the 1. Production counter
the input will be ignored.
To Next Page
Loading...
