Leibinger Jet 3 - PrintGo Repetitions Configuration

Group 8 Job editor Page 242
Release R2.0 LEIBINGER JET3
8.5 Parameter settings
INFORMATION
You will find further information regarding the calling of the several
submenus and the processing of settings in the chapter Parameter
setting tools!
8.5.1 Print parameter
In the dialog box <Print Parameter > you can commit the kind of text output, select
the PrintGo source and you can activate or deactivate the monitoring functions.
The following settings can be carried out:
 PrintGo-Delay
 Drop Flighttime
 PrintGo-Distance
 Selection of PrintGo Source
 PrintGo-Repeat
 Selection of function PrintGo-Gate
 PrintGo-Holdoff Distance
 Selection monitoring functions
8.5.1.1 PrintGo-delay
The setting allows the delay of the text output by the entered value. The input
happens in the measurement which has been selected in the basic settings.
The set value is shown on the accordant display field.
As higher the entered value, as later starts the print.
Figure 130
PrintGo-delay
PrintGo-delay
Text (beginning)
Print delay
PG signal