Leibinger Jet 3 - Meter Go Function for Length Specifications

Group 8 Job editor Page 243
Release R2.0 LEIBINGER JET3
8.5.1.2 PrintGo-distance
The setting defines the distance by the set value between the several text outputs.
The input happens in the measurement which has been selected in the basic settings.
The set value is shown on the accordant display field.
As higher the entered value, as higher is the distance between the single prints.
Figure 131
PrintGo-distance
PrintGo-distance
ATTENTION
If the Print-Go distance has been selected too small, Print-Go errors
can be caused, because a print has been not printed completely during
a new print should be already started!
Example of error:
text
(print)
PrintGo - distance
text
(print)
Print-Go distance
too small
Print-Go distance
correct