Leibinger Jet 3 - PrintGo Source (Print Start Control)

Group 8 Job editor Page 247
Release R2.0 LEIBINGER JET3
Picture 12 shows the function diagram of the example.
After 32 meters the print out stops for e.g. print head cleaning.
Nevertheless the JET3 is still receiving PrintGo signals. Because of the
<Counter Increment> setting with PrintGo (see picture 3) these signals
can be used to keep the counter updated.
Therfore the counter always has the current meter number no matter
whether there are print outs or not. So after the work on the print head
the print out can be resumed with the correct meter number.
Picture 12 – Example function diagram