Leibinger Jet 3 - End Value Configuration; Leading Zeros Adjustment; Step Width Configuration; Repetitions Setting

Group 8 Job editor Page 293
Release R2.0 LEIBINGER JET3
8.7.3.1 Counter parameter
On the <Counter> tab the basic counter settings are defined.
Figure 155
Print elements: counter settings
1 – <Counter> tab
10 – Tab bar <Object settings>
2 – Display field <Counter digits>
11 – Display field <Start value>
3 – Checkbox <Left hand zeros>
12 – Display field <Initial value>
4 – Display field <Step width>
13 – Display field <End value>
5 – Display field <Repetition>
14 – Selection <Counter (Loop/Stop)>
6 – Drop-down list <Count increment>
15 – Drop-down list <Counter reset>
7 – Selection <Counter direction>
16 –<Cancel> Button
8 – Checkbox <Don’t print>
17 – <OK> Button
9 – Checkbox <Global counter>
10
2
3
1
4
5
6
7
8
9
11
12
13
14
15
16
17