Leibinger Jet 3 - Switching the Device Off

Group 6 Operation – Elements and procedures Page 80
Release R2.0 LEIBINGER JET3
ATTENTION
Each product counter has to be reset separately!
If job counters (object counters) whose existing settings <Counter
Reset> have been applied with the attribute „Product Counter“ are
available in the current job, they will be also reset.
You will find further information also in the chapter Change product
counter as well as in the chapter Product counter!
6.5.5 Change product counter
(Change value)
Example: With only one product counter
Proceeding:
 Press on the status field <Product Counter> (1).
 A safety query (2), if the counter should be really changed is faded in.
 Confirm the query by pressing on the button <OK> (3) or cancel the process
with the button <Cancel> (4).
 The window <Product Counter Settings> (5) is faded in.
 Change the value of the counter with the Arrow keys (6). The value of the counter
will be increased or reduced by pressing on the corresponding buttons.
or
 Click in the Counter display field (7). The Numeric keypad (8) opens for input.
INFORMATION
Note! Each counter has to be change separately! The selection happens
with the according tab in the dialog box <Product Counter Settings>.
You will find further information regarding the operation with Numeric
keypads in chapter Numeric keypad!
You will find further information also in the chapter Reset product
counter as well as in the chapter Product counter!
 Confirm the change of values by pressing on the button <Set> (9) or cancel the
process with the button <Cancel> (10).