Flexacam C3 User Manual General Notes 7
Safety Instructions
Description
O The individual modules fulfill the high
requirements for observation and docu-
mentation of the Flexacam C3 camera.
Intended use
O Refer to "Safety Concept" booklet
Non-intended use
O Refer to "Safety Concept" booklet
Never use the Flexacam C3 or its components
for diagnostic procedures if it is not expressly
intended for such use.
The camera and accessories described in this
user manual have been tested for safety and
potential hazards.
The responsible Leica affiliate must be consul-
ted whenever the camera is altered, modified
or used in conjunction with non-Leica compo-
nents that are outside of the scope of this user
manual!
Unauthorized alterations to the camera or
noncompliant use shall void all rights to any
warranty claims.
Place of use
O Refer to "Safety Concept" booklet
O Electrical components must be placed at
least 10 cm away from the wall and from
flammable substances.
O Avoid large temperature fluctuations, direct
sunlight and vibrations. These conditions
can distort the functionality of the camera.
O In warm and damp climates, the individual
components require special care in order to
prevent the build-up of fungus.
Responsibilities of person in charge of
camera
O Refer to "Safety Concept" booklet
Ensure that:
O The Flexacam C3 and accessories are oper-
ated, maintained and repaired by autho-
rized and trained personnel only.
O All operators have read, understood and
observe this user manual, and particularly
the safety regulations.
To Next Page
