79
4. Then open the bottom cover
5. and the rear panel, and
6. remove the film cartridge.
If a film is not correctly attached to the cartridge
spool, e.g. when using bulk film, it can happen
that the end of the film is torn off and has to be
removed from the take-up spool.
To do this:
1. Remove the camera’s bottom cover in a com-
pletely dark room.
2. Hold the camera so that the open bottom
cover is facing downwards.
3. Operate the quick wind lever slowly several
times, until the film cartridge protrudes far
enough from the camera for you to grasp and
remove it. If necessary, lightl
y tap the camera
on your hand.
10b10a
To Next Page
Loading...
