Please read operating instructions carefully before
use and keep for further reference.
Operating Instructions (Translation of the original operating instructions)
Leister FUSION 2/3C/3
Extrusion Welder
GB
DANGER!
Danger when opening up the tool, as live components and connections are
exposed. Therefore, before opening it, unplug the tool to ensure disconnection
from the mains. Electronically conductive material (eg PE-EL) must not be welded.
Incorrect use of the hand extruder (eg overheating of the
material) can present a
fire and explosion hazard, especially near combustible materials and explosive
gases.
Danger – can cause burns! Do not touch bare metal parts and emerging
material while hot. Allow the device to cool. Do not direct stream of hot air or
emerging material towards people or animals.
Warning
The tool must be operated under supervision. Heat can ignite flammable
materials which are not in view.The machine may only be used by qualified
specialists or under their supervision. Children are not authorized to use
this machine.
For personal protection on building sites we strongly recommend the tool be
connected to a RCCB (Residual Current Circuit Breaker) .
Protect tool from damp and wet.
FI
Caution
Application
Welding PE and PP thermoplastics for applications in
• container engineering • pipeline construction
• plastic fabrication • landfill sites and abandoned polluted areas
The voltage rating stated on the tool must correspond to the mains voltage.
If power failure occurs, the hot air blower switch and drive must be switched o
(release locking device).
120
230
To Next Page
Loading...
