Leister UNIPLAN 500 - User Manual

®
Leister Technologies AG
Galileo-Strasse 10
CH-6056 Kaegiswil/Switzerland
Tel. +41 41 662 74 74
Fax +41 41 662 74 16
www.leister.com
sales@leister.com
UNIPLAN
300 / 500
English

Summary

Application

Safety Instructions

Refer to specific section for safety instructions for automatic welders.

Power supply

Details on power cords, extension cables, and on-site generators.

Technical data

UNIPLAN 500 control panel

Function keys

LED status display

Setup menu on the UNIPLAN 500 control panel

Setting up, saving, and selecting recipes (Save Recipes)

Guide to creating, saving, and selecting welding recipes.

Creating a new recipe

Step-by-step process for creating and saving custom recipes.

Modifying an existing recipe

Selecting a recipe

Operating readiness (Eco Mode)

Warnings (only in Advanced Mode)

Machine Setup (only in Advanced Mode)

Reset to defaults (only in Advanced Mode)

Commissioning the UNIPLAN 500

Starting the device

Setting the welding parameters

Welding sequence

Positioning the device

Precautions for placing the hot-air welder for welding.

Welding preperation

Welding Preparation

Commencing welding

Guiding the device during the welding process

Check the parameters while welding is in progress

Welding completion

Turning off the device

Warning and error messages (UNIPLAN 500)

Drive

Heating and drive

Setting the parameter units

Commissioning the UNIPLAN 300

Operating readiness

Pre-operation checks for the UNIPLAN 300.

Check the parameters whilst welding is in progress

Finishing welding

Warning and error messages, UNIPLAN 300

Maintenance of the UNIPLAN 300

Leister UNIPLAN 500 Specifications

General

Brand	Leister
Model	UNIPLAN 500
Category	Welding System
Language	English