MONITOR menue
14 E-LINK D 6060 • D 4060
Blower control
Blower ON/OFF: key < >
The blower status is indicated in the field above the key
A flashing blower symbol indicates the stand-by mode of the
blower. In the stand-by mode, the blower
is automatically switched on as soon as the operating
speed has been reached.
is automatically switched off as soon as the speed is below
the operating speed.
Hydraulic functions
Scroll through the hydraulic functions: key < >
The hydraulic function active in each case (pick-up, cutting
device, support foot, bottom door) is displayed in the field above
the key <
>.
Operating parameters
Select parameter: key < >
Change parameter: keys < > and < >
Compression force
The compression force is adjustable to 0..100% in steps of 1%.
0% = no pressure; 100% = full pressure
Combi presetting
Combi can be set to 0..100 in steps of 1.
Mixer
The mixer can be set to 0..50 in steps of 5.
If mixer = 0 the pressure can be set, not, however, combi.
If mixer <> 0, combi can be set, not, however, the pressure.
length of bale
The bale length can be adjusted to 80..240 cm.
To Next Page
Loading...