LELY E-LINK D 6060 - Standard Error Messages

Error messages
40 E-LINK D 6060 • D 4060
Standard error messages
Standard error messages can appear in all menues. Exception:
"Diagnosis" menue. The standard error messages "Overload"
and "Wire broken" are not displayed there.
Reaction to standard error messages:
 Option 1: Press key < > to remove (acknowledge) the
standard error message. Subsequently, the cause of the
fault must be eliminated.
 Option 2: The standard error message disappears
automatically when the cause of the error has been
eliminated.
Standard error: Overload
An error has occurred which has caused electrical overload of
an output channel. The output is switched off.
The error message can be removed via key; the output,
however, remains blocked up to a new start of the system.
 Remove/acknowledge error messages: press key < >.
Error
ErrorError
Error
Overload
OverloadOverload
Overload
Val. B !
Val. B !Val. B !
Val. B !