EN-25
D OPTIONAL EXTRAS
Wear plates
To avoid excessive wear and tear of the skids as a result of abrasion,
the SPLENDIMO mower can be equipped with wear plates that are
fitted underneath the skids.
These wear plates can be replaced easily and inexpensively. They
are available in thicknesses of 4 or 8 mm.
Topping skids
By fitting so-called topping skids underneath the skids, the cutter
bar of the SPLENDIMO mower can mow somewhat higher above
field level in rough conditions. In that case, the mowing height also
increases by approximately 3 cm so that the knives do not dig into
the ground. This may be important when mowing fallow land or in
nature landscapes.
The turf is spared because the knives do not dig into the ground. The
cutter bar, too, is spared since it is not hit by stones, branches, etc.
Agitators
In certain conditions the mower discs may have difficulty
transporting the crop across the cutter bar. Agitators can be fitted on
the mower discs.
These agitators provide a better grip on the crop, resulting in an
improved crop flow.
Spreading kit
The conditioners of the SPLENDIMO MC mower are prepared for
the installation of so-called spreading fins, which allow the crop to
be dispersed across the full width of the cutter bar. Depending on
weather conditions, one tedding operation may be saved.
Crop divider
When mowing very long crops, the grass still to be mown on the
outer side of the machine may tend to build up. A crop divider is
available to ensure that crop that has not been mown is pushed to the
side, thus preventing it from building up.
Supplement D
To Next Page
Loading...