Page 12
MAINTENANCE INSTRUCTIONS
HELPFUL HINTS
The safety level given by the design of this equipment can only be
maintained when the equipment is regularly examined for damage and
wear. Inoperable components should be replaced immediately or the
equipment should be put out of use until it is repaired. Read all mainte-
nance instructions thoroughly before beginning work.
All references to the right or left side and to the front or back are
made as if you were on the exercise equipment ready to exercise. For
example, the belt is on the right side of the bike.
TOOL LIST
The following tools are needed to perform service and maintenance:
• Combination wrench (included)
• Metric allen wrenches (included)
• Phillips screwdriver
• Shimano
®
-compatible bottom bracket tool + 1/2" driver
• Lock ring removal tool
• Bicycle crank arm puller
INITIAL SERVICE
Upon receiving your equipment, use a soft clean cloth to wipe off the
dust that may have accumulated during shipping. Your equipment will
need minor assembly. Refer to the "Installation Instructions" section of
this manual for details.
PREVENTIVE MAINTENANCE
Refer to the appropriate "Parts Removal and Replacement" section of
this manual for all disassembly and assembly instructions. If you experi-
ence any problems, contact our Customer Service Department at (425)
482-6773.
To Next Page
Loading...
