Page 13
Daily
1. Wipe down the LeMond
®
RevMaster
™
after each use to remove
sweat and moisture. Use soap and water, or a diluted non-abrasive
cleaner solution. Rinse to remove detergent residue and then dry.
2. If your bikes are used frequently in group exercise sessions, inspect
for loose pedals prior to starting any class. Tighten any loose pedals.
Weekly
1. Inspect the brake pad for excessive wear or dryness. If necessary,
lubricate the leather brake pad with 3-N-ONE® oil. If the sponge
padding is showing through the brake pad, replace the brake pad.
2. Wipe down the flywheel with WD-40
®
. This product will clean the
surface of the flywheel and provide a protective barrier against
moisture.
Monthly
1. Inspect the belt for correct alignment and tension. A properly
tensioned belt will not slip when pedaling the bike standing up. Check
the belt for excessive wear. Replace any belt that is cracked, frayed,
or otherwise non-uniform.
2. Inspect the bottom bracket assembly for looseness. The left bearing
cup is adjustable, and over time may loosen. With a small rubber
mallet, tap on the crank bolt on both sides If you see side to side
movement you must remove the crank arm(s) and properly adjust the
bearing cup(s).
MAINTENANCE INSTRUCTIONS
To Next Page
Loading...
