6
1. Adaptor holder, use the adaptor in this holder for 45 RPM records.
2. Platter, place the records on the platter.
3. Tone arm
4. Tone arm lock, use this to lock the tone arm.
5. Dust cover, open or remove the dustcover while operating.
6. USB Socket, use this connection to connect this turntable to a computer.
7. Audio output, use this connection to connect the turntable to a audio system.
8. Power cable, connect this cable to a power source.
9. Tone arm lift button, press here to list the tone arm.
10. Stop button, press this button to stop the playback
11. Speed button, select the rotating speed, 33 or 45 rpm.
Installing the device
Where to install?
Locate the unit away from direct sunlight, soft indirect lighting is recommended for
comfortable viewing. Place the unit on a sturdy platform of which the surface should be flat.
This will prevent it from falling over. Make sure the unit is located in a position where it
cannot be pushed or hit by objects, as pressure will break or damage the unit, and so that
small objects cannot be inserted into the ventilation slots or openings in the cabinet.
How to install?
Connect the power cable to the wall outlet.
Connect audio plugs to a input on your mixer or audio system.:
Red plug into R/H channel input.
White plug into L/H channel input.
Note: This turntable has a built-in amplifier to avoid damage on the turntable or your
audio-system. Do not connect this turntable to your audio-system by using the
phone-input because this input is amplified also.
Maintenance
To replace the stylus (fig. A)
Use the tone arm lock clip to lock the tone arm.
Pull the stylus in the direction of arrow (A) and remove it.
Put in the new stylus following the reverse procedure.
To disassemble the cartridge (fig. B)
Use the tone arm lock clip to lock the tone arm.
Remove the stylus (see section "to replace the stylus).
Release the pick-up head by pushing the cartridge in the direction of the arrow.
Disconnect the three cables link wires at the level of the pick-up head.