LENCO MC-141 User Manual

SYSTEM CONNECTIONS
Power is fed to the unit even when it is in standby.
Ensure that the unit is switched off before you make any connections.
FITTING THE BATTERIES INTO THE REMOTE CONTROL
REMOTE CONTROL UNIT
VOLUME BUTTON
VOLUME BUTTON
TUNE + NEXT BUTTON
ON / STANDBY BUTTON
+10 TRACK BUTTON
FOLDER UP / P + BUTTON
ENTER /PLAY
/PAUSE BUTTON
FUNCTION BUTTON
STOP / BAND BUTTON
TUNE - BACK BUTTON
FOLDER DOWN / P- BUTTON
-
+
ID3/DISPLAY BUTTON
MEMORY/CLOCK/ADJ. BUTTON
- 10 TRACK BUTTON
GB 1
Remove the battery door. Insert the batteries (2 x AAA SIZE battery, not included) and ensure that the polarities are correct (see
illustration inside the battery compartment).
Close the battery door.
To an AC outlet
LEFT SPEAKER
RIGHT SPEAKER FM WIRE ANTENNA
* LEFT/RIGHT
SPEAKER SOCKET
Connect the black wire to the (-) terminal.
Connect the white wire to the (+) terminal.
SPEAKER WIRE
AC POWER CORD
SPEAKER WIRE
MUTE BUTTON PRESET EQ BUTTON
ST./MO./PLAY MODE BUTTON
TIMER/SLEEP BUTTON

LENCO MC-141 Specifications

CD Section

channels	2 channels
signal to noise ratio	60 dB
sampling frequency	44.1 kHz 8 x over sampling

Radio Section

FM tuning range	87.5 - 108 MHz
AM tuning range	522 - 1620 kHz
FM antenna	Wire antenna

General Specifications

output power	2 W + 2 W
power consumption	17 WATTS
power source	AC : 230V ~ 50Hz

Weight and Dimensions

main unit dimensions	175 (L) x 207 (D) x 133 (H)mm
speaker dimensions	110 (L) x 174 (D) x 133 (H)mm
weight	2.63 Kgs