LENCO MC-141 User Manual

GB 2
Press VOLUME +/- to adjust volume level. Volume level is shown on the display.
FOR PRIVATE LISTENING
Pluginheadphones(ø3.5mmstereomini-plug)tothePHONESjack.
Whenheadphonesarepluggedin,thespeakersareautomaticallydisconnected.
TO ADJUST THE VOLUME
ADJUSTING THE SOUND
PRE-SET EQ
Preset EQ : FLAT, JAZZ, ROCK, CLASSIC, POP.
Press PRESET EQUALIZER button to select your preferred
sound, preset mode is shown on the display.
1. Powerison/offbypressingSTANDBYbutton.
2. Thefunctionischangedcyclically
 bypushingFUNCTIONbutton:
CD TUNER AUX .
POWER ON/OFF AND FUNCTION CHANGE
STANDBY
VOL. +
VOL. -
PRESET EQ
The mute on/ off is changed cyclically by pressing MUTE
button.
The“mute”markisonduringmuteison.
The mute on is cancelled in case as shown below.
a. The power is off/on
b. The Volume is adjusted by the VOL +/- button.
MUTE ON/OFF
MUTE
AUX IN
Connect an external LINE OUT to AUX. IN socket at the back of the unit.
Press the FUNCTION button and select AUX mode.
( AUX IN CABLE NOT INCLUDED )
(Plugotherendinto
external source )
FUNCTION
AUX. IN
FUNCTION

LENCO MC-141 Specifications

CD Section

channels	2 channels
signal to noise ratio	60 dB
sampling frequency	44.1 kHz 8 x over sampling

Radio Section

FM tuning range	87.5 - 108 MHz
AM tuning range	522 - 1620 kHz
FM antenna	Wire antenna

General Specifications

output power	2 W + 2 W
power consumption	17 WATTS
power source	AC : 230V ~ 50Hz

Weight and Dimensions

main unit dimensions	175 (L) x 207 (D) x 133 (H)mm
speaker dimensions	110 (L) x 174 (D) x 133 (H)mm
weight	2.63 Kgs