LENCO MDV-3 - FM;AM RADIO OPERATION

- 15 -
BASIC OPERATION
FM/AM RADIO OPERATION
1. Enter FM/AM Function
In the turn-on or play status, press the FM/AM button on the remote controller, enter FM status,
press the button again to enter AM status.
2. Select Bands
1) directly input frequency: press the T/F button on the remote controller, input the frequency that
you want directly.
2) Select band by pressing Tune - or Tune+ button: under some frequency, press the button, the
frequency will be up or down on the step. The step of FM is 0.0 5 MHz the step of AM is 9 KHz.
3) Select band by pressing number buttons: you may select the bands that have been saved by
pressing the number buttons. For example: press 10+ button twice, 5 button once, you may
select the 25th band. Press the CH - or CH+ butt on, the band will be switched up or down.
4) Automatically search bands: press the Search button, this unit will start to search bands from
the lowest part to highest part automatically. Meanwhile the searched bands will be saved
orderly. Press the button aga in to stop searching.
3. Save Bands
Press the Save button, will appear on the VFD, that means that saving the current frequency of
band. For example: If you want to save 99.3 MHz in 28th, please press 10+ button twice, 8 butto n
once, then press T/F button to input 993, then press Save button to save this frequency.
4. Soundtrack Selection
Press L/R(MO/ST) button, you may select Mono and Stereo soundtrack output in FM status. When
you select Stereo, the VFD will display . If the signal is not strong enough, you cannot select
Stereo. (Note: No stereo in AM status)
5. Exit FM/AM Status
Press the Play/Enter button to exit FM/AM status and enter the disc playing.
Hints for better Reception:
Please vary the direction of the antenna to find the strongest signal for each station.